GENERAL MERCHANDISE SECTION RED PART NUMBERS INDICATE NEW PARTS 10-9 1 2 3 4 5 6 7 8 9 10 11 CONTENTS ELECTRICAL FRAME FRONT END CONTROL WHEEL ENGINE DRIVE TRAIN FUEL EXHAUST GENERAL REFERENCE Diagnostic Tools & Battery Chargers TWIN SCAN DIAGNOSTIC TOOLS FOR LATE MODELS Fitment Notes Part # Twin Scan II 2001/Later EFI models with Delphi® System & Models with 82731 2003/2006 Carbureted models with 12 pin ignition module J1850 Data Bus Twin Scan 4 Softail models 2011/Later, Dyna 2012/Later & Models with 82743 Touring Models 2014/Later CAN Data Bus • Twin Scan ABS is the updated version with the capabilities of anti-lock brake system (ABS) brake bleeding functions for listed models. • Displays throttle position on new 2008/Later Touring Models with electronic throttle control. • Uses laptop PC for display. Includes Windows software. • Reads and clears diagnostic trouble codes from ECU (Engine Control Unit), TSSM (Turn Signal/Security Module), speedometer and tachometer. • Real time display of engine data on instrument panel type display. • Built-in data logging. Store up to 45 minutes of data. Automatically triggers when a trouble code is set. Shows data before and after code is set. • Includes two analog inputs for air/fuel ratio (AFR). All Twin Scan II units can be upgraded to Twin Scan II+ for use as tuning aid. • Unit measures 3.1” L x 1.6” W x 0.8” H. 82731 82743 ABS Brake Bleeding Functions Tech Note: ABS brake bleeding functions are only available on Twin Scan II ABS units with version 3.0 or higher firmware, that supports the special codes used for ABS brake bleeding. If you attempt to use the ABS brake bleeding functions with older Twin Scan II units, an error message will be displayed. ABS brake bleeding should only be performed by a trained and experienced mechanic. Individual front and rear ABS brake bleeding functions are available. However, the front and rear sections of the ABS system share a common pump, so you should always bleed both sections, starting with the front. • Wall mount type charger plugs into any 2 or 3 hole 10 volt AC receptacle and includes 13 feet of cord. • Two color LED indicates the charging status at a glance. • Battery connection can be made with the alligator clips or permanently with the eyelet terminals. • Male/female connector is compatible with OE Harley plug. • Float mode prevents over charging. • Measures 2” long x 2” wide x 3” tall. AUTOMATIC CHARGER FOR 12 VOLT BATTERIES .75 Amp Part 10522 .75 Amp
RkJQdWJsaXNoZXIy MzYzNTI=