DRIVE TRAIN SECTION RED PART NUMBERS INDICATE NEW PARTS 7-84 1 2 3 4 5 6 7 8 9 10 11 CONTENTS REFERENCE GENERAL EXHAUST FUEL DRIVE TRAIN ENGINE WHEEL CONTROL FRONT END FRAME ELECTRICAL ENGINE/PULLEY NUTS AND WASHERS FOR BELT DRIVE BIG TWIN • Available in a chrome plated acorn style or the standard hex style. • For best results, always install the correct washer, especially on front pulleys that have a removable steel center. Part 77308 Part 75447 Part 75449 Part 75450 Grade 8 Grade 5 Grade 5 (Rpls. HD 24003-55) (Rpls. HD 24003-55) (Rpls. HD 24003-55) Fits Big Twin 4 & 5 speed 1955/2006 with primary belt drive Belt Drive Parts BELT DRIVE IDLER BEARING KIT FOR BELT DRIVE SYSTEM This high quality Primary Belt Drive Idler Bearing Kit is used to adjust the belt tension. Small adjustable serrated plate attaches to the large solid mounted stock plate within the cast inner primary. The roller bearings are permanently sealed for zero maintenance. Note: Not intended for use with polychain belts that have ribs on the outside. Part 77311 Fits Big Twin 4 speed 1965/Later with 1 1⁄2” primary belt drive SPROCKET SHAFT SPACER KITS FOR BIG TWIN Designed to fit over the engine sprocket shaft and accurately align the engine sprocket or belt drive pulley to the clutch basket. Precision ground from 4130 steel to provide flat and parallel surfaces to insure correct alignment. Kit includes one each of .020”, .030”, .050”, .075” and .100” thick spacers. Note: Fits chain or belt primary drive Fits Big Twin 1970/2006 Fits Big Twin 2007/Later Part 65453 Part 65455
RkJQdWJsaXNoZXIy MzYzNTI=