FUEL SECTION RED PART NUMBERS INDICATE NEW PARTS 8-59 1 2 3 4 5 6 7 8 9 10 11 CONTENTS ELECTRICAL FRAME FRONT END CONTROL WHEEL ENGINE DRIVE TRAIN FUEL EXHAUST GENERAL REFERENCE AIR FILTER TO CARBURETOR GASKET FOR TILLOTSON, BENDIX, KEIHIN AND S&S CARBURETORS High Density Latex Gasket fits between air filter and carburetor. This gasket fits Tillotson, Bendix, Keihin and S&S Super B carburetors to most air filters. (Rpls. HD 29058-77) Fits Big Twins Late 1977/1989, Sportster Late 1976/1987 Part 82407F OIL PRESSURE GAUGE ADAPTER KITS FOR BIG TWIN Complete chrome plated Adapter Kits available without oil pressure gauge. For the early generator models (1936/1969), the adapter fits directly into the oil pump, replacing the oil pressure sending switch. For the later Shovelhead and Big Twin Evolution alternator engines 1970/Later, the adapter replaces the top end feed screen plug found on the engine block. Part 85101 Part 85203 Part 85204 Fits Big Twin 1936/1969 Oil Pressure Gauge Adapter Fits Shovelhead 1970/ Later & Big Twin Evolution, all years OIL PRESSURE GAUGE ADAPTERS FOR BIG TWIN EVOLUTION Fits Big Twin Evolution, all years Shown Installed 85207 85208 85206 • Made from 6061-T6 billet aluminum with 1/8” NPT male and female threads. • Available to be used with or without the oil pressure sending unit. • These units must be installed with TeflonTM thread tape to face the dial on pressure gauge at the correct angle. • Oil pressure gauge and sending unit not included. • Oil pressure sending unit found in Sec 6 . OIL PRESSURE GAUGE FITTING KIT FOR BIG TWIN EVOLUTION The Big Twin Evolution kit fits into the engine case, and the oil pressure gauge bolts to the rocker box using strap. Kit is complete with chrome plated adapters to place oil pressure gauge within easy sight. Oil gauge not included. Part 85131 Fits Big Twin Evolution, all years Description Manufacture Part # Oil Pressure Gauge 85207 fitting without sending unit 85208 Oil Pressure Gauge 85206 fitting for use with sending unit OIL PRESSURE GAUGE FITTING FOR ROCKER ARM COVERS Mounts on rocker box. This oil pressure gauge fitting enables you to watch your oil pressure while riding your bike. It replaces the rocker arm shaft end plug and clears all seats and gas tanks. Installation instructions included. Part 85130 Fits Shovelhead and Ironhead Sportster Late 1971/Later Oil Pressure Related & Air Filter Gasket
RkJQdWJsaXNoZXIy MzYzNTI=