FUEL SECTION RED PART NUMBERS INDICATE NEW PARTS 8-47 1 2 3 4 5 6 7 8 9 10 11 CONTENTS ELECTRICAL FRAME FRONT END CONTROL WHEEL ENGINE DRIVE TRAIN FUEL EXHAUST GENERAL REFERENCE 3.5 Quart With Battery Tray Fits all HARDBODY FAT-A-TUDE, chopper style, and rigid frames. Also fits OE Softail frames 1984/1999 if our 85152 front tank mount is used. Note: As with any new oil tank, always thoroughly inspect and flush before installing. Flat Side With Center Fill Domed Side With Side Fill ROUND OIL TANKS FOR CUSTOM USE Flat Side Domed Side Fill Location Finish Part # Part # Center Fill 86074 86082 Round 86080 –– Side Fill 86075 86083 Round 86081 –– Description Part # Front Oil Tank Mounting Bracket 85153 Fill Plug 85017 Front Rubber Mounts (Pack of 3) 83563 REPLACEMENT PARTS • These tanks feature our exclusive oil return routing system. The internal oil return tube is extended, allowing it to dump the hot returned engine oil to the far left side of the oil tank. This keeps the returned oil as far away from the feed line, creating an efficient circulating effect. • Lower left hand relief for use with a chain or belt rear drive. • The flat side tanks measure 11 7/8” long & the domed side tanks measure 12 1/2” long • Tank bodies measure 6 1/2” O.D. • Made from 16 gauge steel to resist cracking. • 100% TIG welded for maximum strength. • Includes heavy duty front mount and fill plug. • Use with Softail size battery and OE style rear tank mount. • Uses 1/8-27 NPT fittings for vent, return & feed lines, and 1/4-18 NPT fittings for oil drain. See 8-40 . • For best results, use our 80627 rubber mounts and 10807 battery cushion. NOTE: Due to inherent oxidation during storage of oil tanks as well as oxidation associated with chrome plating process, all oil tanks purchased require thorough cleaning with a rust removing chemical liquid prior to use. Shown Installed Oil Tanks FRONT MOUNT FOR ROUND OIL TANK Shown Installed Fits Softail 1984/1999 with battery tray type round oil tank Part 85152 • Mounts to the downpost for a simple way to attach the front of the oil tank. • 1/4” thick steel for maximum strength.
RkJQdWJsaXNoZXIy MzYzNTI=