FUEL SECTION RED PART NUMBERS INDICATE NEW PARTS 8-34 1 2 3 4 5 6 7 8 9 10 11 CONTENTS REFERENCE GENERAL EXHAUST FUEL DRIVE TRAIN ENGINE WHEEL CONTROL FRONT END FRAME ELECTRICAL Custom Fit Oil Lines & Fittings PROFLEX™ BRAIDED OIL LINES & FITTINGS FOR CUSTOM USE Not all braided stainless steel oil line is the same, and the Russell Proflex is in a class all by itself. Most braided stainless steel line is good for about 250 PSI, but the Proflex can easily withstand 1000 PSI and is used by many Nascar® and top fuel drivers. These kinds of PSI capabilities may sound like overkill, because they are, but if you use anything less, you will never be completely without doubt. This oil line is constructed with a stainless steel outer braid that resists abrasion and corrosion and features a synthetic rubber liner with a nylon inner braid that will not collapse under extreme heat, yet is still very flexible to permit easy routing This #6 size oil line has a 11/32” I.D. x 5/8” O.D.” I.D. and is designed to be used with the Full Flow™ Hose Ends and Adapter Fittings found below. These #6 Adapter Fittings are made with the same Endura coated aluminum as our hose ends and have a matching 37˚ sealing surface. The compression fit adapter is designed for oil tanks that incorporate welded-in type oil fittings with a .380” O.D. and a single upset at the end (similar to what is found on 1986/1999 Softail oil tanks). All other fittings have a NPT (pipe thread) end. Part 83038 6 foot Part 83039 10 foot Part 83041 20 foot Part 83583 3/8” Proflex Oil Line Adapter Fittings NPT - 90˚
RkJQdWJsaXNoZXIy MzYzNTI=