FUEL SECTION RED PART NUMBERS INDICATE NEW PARTS 8-22 1 2 3 4 5 6 7 8 9 10 11 CONTENTS REFERENCE GENERAL EXHAUST FUEL DRIVE TRAIN ENGINE WHEEL CONTROL FRONT END FRAME ELECTRICAL STRETCHED CHOPPER GAS TANKS FOR CUSTOM FRAMES • Frame requirements: A) 4” stretch in the front down tubes. B) 3” minimum stretch in the backbone. C) Backbone O.D. cannot exceed 1 3/4”. • Mounting brackets are rubber isolated to prevent vibration cracks. • “Weld to frame” brackets recess in the bottom of the tank for a hidden look. • The raised bung type tank and the flush mount bung type tanks are available with your choice of Flush Mount or Spinner style gas cap. • Tapped 3/8-24 at rear of tank for gas crossover line (not included). • Use with 13/16” (22mm) fuel valve. 4.1 Gallon Style 4.7 Gallon Style Raised Bung Requires 1982/ Later Cap Flush Mount Bung Shown Installed Included Mount Kit Flush Type Mounting Brackets Shown Installed Note: These tanks must be pressure tested, sealed and pre-mounted on frame to verify compatibility of all related parts before painting. Recessed Brackets Rubber Isolated Crossover Provision Deep Tunnel 4.1 Gallon Tanks have a 22” tunnel length & 4.7 Gallon Tanks have a 23” tunnel length Bung Style Cap Style Flush Mount Spinner Tunnel Length Bung Style Cap Style Part # 22” 1982/Later Not Included 81082 Tunnel Length Bung Style Cap Style Part # 23” Flush Flush Mount 81073 Flush Spinner 81087 Description Part # Spinner cap with O ring (chrome plated) 80025 Cap O ring (pair) 80662 Mounting bracket kit (weld to frame) 80668 includes brackets, rubber isolators & bolts REPLACEMENT PARTS Gas Tanks 4.1 Gallon Tanks 4.7 Gallon Tanks
RkJQdWJsaXNoZXIy MzYzNTI=