ENGINE SECTION RED PART NUMBERS INDICATE NEW PARTS 6-64 1 2 3 4 5 6 7 8 9 10 11 CONTENTS REFERENCE GENERAL EXHAUST FUEL DRIVE TRAIN ENGINE WHEEL CONTROL FRONT END FRAME ELECTRICAL Screw Kits & Tappet Tools TAPPET BLOCK SCREW KITS FOR BIG TWIN • Exceeds OE specifications. Acorn Head Hex Head 12 Point Head Button Head Allen Fits Style Rpls. HD # # of Pieces Special Notes Part # Big Twin 1936/Early 1976 cases & Button –– 16 1/4-24 Thread w/washers 60098 Early Tappet Blocks for Head Taper Head Screws Allen Hex 18660-53 16 1/4-24 Thread w/washers 60086 Big Twin 1936/Early 1976 Cases & Allen –– 8 1/4-24 Thread 60093 Late Tappet Blocks for 12 Point –– 8 1/4-24 Thread 60090 Flat Head Screws Big Twin Shovelhead & Evolution Acorn –– 8 1/4-20 Thread 65345 Late 1976/Later Cases Allen –– 8 1/4-20 Thread 60092 12 Point 3770 8 1/4-20 Thread 60089 Twin Cam, all years Allen 4741A 16 1/4-20 Thread w/washers 61402 TAPPET ADJUSTMENT TOOL TAPPET POSITION HOLDING TOOL This tool simplifies the way to verify proper tappet adjustment. After adjusting the tappet, simply insert the tip of this tool under the hydraulic unit retaining clip, above the pushrod seat. Similar to a “Go No-Go Gauge”, if the tip doesn’t fit between the clip and the pushrod seat OR if there is up and down endplay, the tappet is out of adjustment. Only when the tip fits nicely with no endplay, is the tappet properly adjusted. Fits Twin Cam 1999/Later, XL & Buell (except 1125R) MilwaukeeEight® 2017/Later. Expert technicians know that keeping the same parts operating in their original position and direction is a good idea. This is especially true with the tappets in Harley-Davidson® engines. Whenever the tappets are removed, in the case of a camshaft change or complete tear down, this new Tappet Position Holding Tool allows the tappets and anti rotation pins to be safely and accurately stored for proper reinstallation. Tappet locations are clearly referenced on the tool, which also serves to protect the tappets from damage when removed from the engine. Part 60864 Part 61984 Fits most hydraulic tappets, OEM & aftermarket, for Milwaukee-Eight®, Twin Cam or Evo. (Does not work on Solids, JIMS Hydrosolids or other limited travel tappets) MAGNETIC TAPPET HOLDER FOR TWIN CAM & MILWAUKEE-EIGHT® This new tool will easily hold the tappets in the tappet bores when the cam is removed. Simply install the tool over the tappet cover and the rare earth magnets will magnetically hold the tappet in place while performong any cam chest work. Designed to work on both Twin Cam & Milwaukee-Eight® engines. Includes a form fitted tray that will protect the magnets from damage when stored. Part 60876
RkJQdWJsaXNoZXIy MzYzNTI=