GENERAL MERCHANDISE SECTION RED PART NUMBERS INDICATE NEW PARTS 10-63 1 2 3 4 5 6 7 8 9 10 11 CONTENTS ELECTRICAL FRAME FRONT END CONTROL WHEEL ENGINE DRIVE TRAIN FUEL EXHAUST GENERAL REFERENCE Engine Lower End Tools • Designed to remove both front and rear counter balance shaft assembly from the left engine case. • Use on both 96” and 110” Beta engines. • Use with 60760 installation tool, found on Page 10-60 . • Includes instructions. • Use to hold the starter pinion gear in place during service. • Fits both 9 tooth and 10 tooth starter gears. BALANCER SHAFT REMOVAL TOOL FOR SOFTAIL Fits Softail 2007/Later (Rpls. HD 48457) Part 60763 STARTER PINION GEAR TOOL Shown in use. Part 17099 GEAR SHAFT NUT SOCKET WRENCH FOR BIG TWIN • Fits pinion gear nut which secures pinion gear to gear shaft. • 1/2” drive. Fits Big Twin 1954/1992 (Rpls. HD 94555-55A) Part 60723 Part 60821 TIMKEN® BEARING SIMULATOR TOOL • Simulates the outer Timken bearing on the engine sprocket shaft. • Helpful when setting up clearances for a stroker engine. • No longer will you have to install the left Timken bearing to set your clearances, such as degreeing the breather opening, then have to press the crankshaft back out of the left case half to do your final clean up. • This black delrin plastic simulator will not damage the Timken race when rotated. • Includes instructions. For Big Twin 1970/2002 PINION GEAR TOOL WITH COLLAR FOR BIG TWIN & SPORTSTER Use to remove pinion gear on all Big Twin (except Twin Cam), and Sportsters, all years. Use to install pinion gear to the proper depth on Big Twin 1951/1953. (Rpls. HD 96830-51) Part 60722
RkJQdWJsaXNoZXIy MzYzNTI=