GENERAL MERCHANDISE SECTION RED PART NUMBERS INDICATE NEW PARTS 10-60 1 2 3 4 5 6 7 8 9 10 11 CONTENTS REFERENCE GENERAL EXHAUST FUEL DRIVE TRAIN ENGINE WHEEL CONTROL FRONT END FRAME ELECTRICAL Engine Top & Lower End Tools ROD ALIGNMENT TOOL FOR MOST MODELS Use this steel Rod Alignment Tool by inserting through the connecting rod’s wrist pin bushing to check for bend or twist of the connecting rod. Model & Year Tool O.D. Part # All models & years .791” 60727 (except Twin Cam) PISTON WRIST PIN REMOVER FOR ALL MODELS WRIST PIN REMOVER ADAPTER Part 60833 Part 60851 Part 60760 With this tool, one person can easily remove the connecting rods wrist pin from the piston, with no fear of damage to the wrist pin bushing, connecting rod or the piston. Fits all models, all years. (Rpls. HD 42320) The new Milwaukee-Eight® engine uses different wrist pins compared to other Harley-Davidson® engines. This tool quickly and easily removes the wrist pins in these new engines. To reduce cost and save tool box space, this adapter is used with our existing wrist pin tool Part # 60833 Use with existing JIMS® wrist pin remover tool Part #60833, purchased separately • The balancer shaft installation tool is used to align and safely install a new balancer bearing and counter balancer shaft into a TC 96” or 110” “B” Softail engine case. • Use our 60763 tool, found on Page 10-63 to remove the balancer shafts. • The right side bearing tool removes and installs the outboard balancer bearing on the chain guide support plate. • Includes instructions. BALANCER/BEARING SERVICE TOOL SET FOR SOFTAIL Shown in use. Balance shaft installation tool. (Rpls. HD-48309) Right side bearing R&R tool. (Rpls. HD-48474) Fits Softail 2007/Later
RkJQdWJsaXNoZXIy MzYzNTI=