ELECTRICAL SECTION RED PART NUMBERS INDICATE NEW PARTS 1-9 1 2 3 4 5 6 7 8 9 10 11 CONTENTS ELECTRICAL FRAME FRONT END CONTROL WHEEL ENGINE DRIVE TRAIN FUEL EXHAUST GENERAL REFERENCE Battery Cables, Boot, Mounts, & Cushions BATTERY CUSHIONS FOR SOFTAIL Cut down on vibration and loose connections. The special inset design of these cushions will keep your battery from moving around. Made of natural black rubber, they are acid, oil and heat resistant. Part 10511 Part 10514 (Rpls. HD 66210-97B) Fits 1997/1999 Fits Late 1985/1996 (Rpls. HD 66210-85B) Fits Big Twin 1970/Later (Rpls. HD 70584-94) BATTERY CUSHION FOR ALL MODELS BATTERY BOOT FOR POSITIVE BATTERY CABLE This 5” x 8” Battery Cushion is made out of high quality neoprene foam, which is non-absorbent and retains its shape well under pressure without flattening. This battery cushion has adhesive stick backing to make sure it stays in place. (Rpls. HD 66103-74A) Part 10807 Part 17765 Model & Year Style Description Mfg. Part # Big Twin 4 speed 1965/1986, A Standard Duty 80616C XLH 1967/1978, A Standard Duty 80669 XLCH 1970/1978 (Rpls. HD 62563-65) Custom use where a longer A Heavy Duty with 80672 stud is required at one end. one 1/2” long stud & one 3/4” long stud. RUBBER MOUNTS FOR BATTERY CARRIER TRAY BATTERY CABLE SETS FOR MILWAUKEE-EIGHT® • Rubber mounts designed to help isolate vibration transmitted to the battery carrier tray. • Also used for mounting instrument dash panels and oil tanks. • Mounting studs have a 1/4-20 thread x 1/2” long (except as noted). • All American made (D&S Performance) mounts exceed OEM specifications and feature a manufacturer’s two year warranty. Rubber Style A Shown Installed • Black rubber boot for use on the positive battery cable to the starter post. • Helps keep moisture off of starter cable post. • Great for custom applications also. • Sold in pack of five. Fitment Part # Fits all Softail Milwaukee-Eight® 2018 10453 10453 Battery cables by Sumax are the ultimate high performance cables on the market today. Uniquely designed, these black 2 gauge, 180 amp rated cables will transfer more cranking power (with less voltage drop) than any other cable offered by their competitors. These very fat and very flexible cables have over 2000 bare strands of copper wire, are covered with special vinyl insulation and cased in a synthetic thermo rubber jacket. Terminals are closed-barrel style made of tinned copper (1/4” & 5/16” eyelets). Sealed insulated black heat shrink tubing means no moisture will get in these cables. For bikes with starting problems or for a high powered one-two punch, add a set of ThunderVolt wires to the mix.
RkJQdWJsaXNoZXIy MzYzNTI=